Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Bathroom Remodeling: The Long Beach Owner’s Guide
KraftMaid bathroom remodeling in Long Beach typically runs $9,000-$28,000 for a full project, with cabinet-only refreshes starting around $4,000-$13,000 for installation. We stock KraftMaid-compatible hardware, hinges, drawer slides, and door fronts for same-day replacement on most Classic and Canvas series units. Most Long Beach homeowners discover their KraftMaid components are failing when soft-close drawers start slamming, door hinges sag on the humid side of the bathroom, or the painted finish bubbles near the shower envelope in older Belmont Shore and Bixby Knolls homes where ventilation was never upgraded.
Which KraftMaid Models This Applies To
KraftMaid organizes its bathroom lines into three tiers: the Classic series (standard overlay, most common in Long Beach homes built 1995-2010), the Canvas series (full-overlay contemporary frameless, popular in Signal Hill and Alamitos Heights renovations since 2015), and the Vantage series (semi-custom with extended stile options, usually special-order). The critical compatibility gotcha is the hinge boring pattern: Classic uses a 3/4-inch overlay with 35mm cup holes on 4-inch centers, while Canvas shifts to a 1 3/8-inch full-overlay with 5-inch centers. Measure your existing door from the edge to the start of the hinge cup; if you order the wrong overlay, the door will not close flush against the face frame.
To identify your series, check the interior of the sink base or a drawer box for the KraftMaid foil label with a six-digit PO number and two-letter plant code. We carry Blumotion soft-close hinge packs, undermount drawer slide sets, and door-front blanks pre-drilled for both patterns. OEM KraftMaid hardware is stamped with the brand name; quality aftermarket equivalents from Blum and Salice match the spec and carry comparable cycle ratings at roughly 15-20 percent less. For painted finishes, we source Sherwin-Williams conversion varnish matched to KraftMaid’s current palette, which matters because the original “Canvas” white from 2018 is not the same formulation as 2024.
Signs Your KraftMaid Bathroom Remodeling Is Failing

- Drawers slam or resist closing. The Blumotion piston in the slide mechanism has lost its gas charge, common after 7-10 years in Long Beach’s coastal humidity. Salt air accelerates seal degradation on homes west of Pacific Coast Highway.
- Door fronts hang crooked or rub the frame. The 35mm hinge cup has wallowed out in the MDF stile, or the mounting plate screws have stripped their pilot holes from repeated adjustment. This happens faster in bathrooms without exhaust fans running full cycles.
- Painted finish bubbles or peels near the shower. Steam penetration has compromised the conversion varnish topcoat, usually because the original installer skipped the recommended 2-mil build. In Naples and Belmont Shore, we see this where showers back directly against exterior walls with poor insulation.
- Sink base floor shows water staining or swelling. The 3/4-inch plywood bottom has taken repeated splash-over; KraftMaid’s standard sink mat was never installed or has shifted. Particle board bottoms on pre-2010 units delaminate faster than plywood.
- Pulls or knobs loosen repeatedly. The 8-32 machine screws have stripped in the MDF door front, often because a homeowner over-tightened hardware against a hollow-core door. Solid hardwood stile doors hold hardware threads longer.
Before
AfterReplacement Cost & What’s Included
| Scope | Long Beach Price Range | What’s Included |
|---|---|---|
| Full bathroom remodel with KraftMaid cabinets | $9,000-$28,000 | Demo, rough plumbing, electrical, cabinets, countertops, fixtures, tile, paint; permits and inspections included |
| KraftMaid cabinet installation only | $4,000-$13,000 | Delivery, leveling, shim and scribe to out-of-plumb walls, hardware install, door and drawer adjustment |
| Countertop (Cambria, Silestone, or quartz) | $2,000-$6,500 | Templating, fabrication, undermount sink cutout, installation, silicone seal |
| Hardware refresh (hinges, slides, pulls) | $800-$2,500 | Parts, removal and reinstall of door fronts, adjustment to factory spec |
| Single door or drawer front replacement | $300-$800 | Matched finish, drilled for hardware, installed and aligned |
What drives the range: bathroom square footage, whether we’re moving plumbing (toilet, tub, or wet-wall relocation adds $2,000-$5,000), and countertop material selection. Cambria runs higher than Silestone; both outlast laminate by decades. Every quote is a flat written price with line-item scope before work starts, under Clause 1 of the Haven Standard. The 365-Day Done Right Promise covers workmanship; manufacturer warranties cover product defects. No change proceeds without a signed change order, which is why our projects finish within a few percent of the agreed number.
DIY or Call Us?

There’s a safe middle ground here. A homeowner can swap a pull or knob with a screwdriver, and can adjust hinge alignment using the two cam screws on a Blum hinge (turn the front cam to move the door left-right, the rear cam for in-out). What we do not recommend: removing a wall-mounted vanity without confirming electrical and plumbing shutoffs, or attempting to reface a drawer box when the slide mechanism is under spring tension. The undermount slide on a KraftMaid deep drawer carries 75 pounds of load; if the rear bracket releases unexpectedly, the box can drop on your foot or snap the front joint.
We carry the common KraftMaid hinge and slide configurations on our Long Beach trucks, and we document every visit with a photo record you receive by text. If you’re matching a discontinued finish or a specific Canvas door style, we’ll measure, photograph the label, and confirm availability before we quote. Call (424) 567-7009 to schedule your free estimate.
FAQs
With proper ventilation, 20-25 years for plywood-box units; particle board construction from before 2010 often shows swelling at 12-15 years in coastal bathrooms. The salt air west of Pacific Coast Highway accelerates hardware corrosion, so we specify stainless or coated hinges for those homes. Call (424) 567-7009 for an exact quote on your replacement timeline - estimates are free.
Yes, if the box is structurally sound. We can replace delaminated sink bases, re-veneer damaged stiles, and retrofit soft-close hardware to pre-2010 units. Replacement makes more sense when multiple boxes are swollen, the layout is dysfunctional, or you want to reconfigure for a larger vanity or walk-in shower. Call (424) 567-7009 for an exact quote - estimates are free.
Typical timeline is 3-5 weeks from demolition to final walkthrough in Long Beach, assuming permits are current and no asbestos abatement is required. Cabinet lead time is currently 4-6 weeks from KraftMaid’s Middlefield, Ohio plant; we order before demo starts so the schedule holds. Call (424) 567-7009 to check current lead times and lock your slot - estimates are free.
We stock Blumotion hinges, undermount slides, and common door-front sizes for Classic and Canvas series on our Long Beach trucks. Special-order finishes, Vantage series components, or matched paint require 1-2 weeks. We are an independent service provider, not affiliated with KraftMaid. Call (424) 567-7009 to confirm we have your part - estimates are free.
Rowan Construction Group Long Beach is independently owned and operated. We source KraftMaid, Cambria, Silestone, and Kohler products through authorized distribution; we do not represent the manufacturers. Every project receives a written price before work starts, a documented photo record on every visit, and the 365-Day Done Right Promise backed by The Haven Standard, not a handshake. Grant Rowan’s approach has stayed consistent since 2007: measure twice, write it down, then build it.
Ready to price your KraftMaid bathroom project? Call (424) 567-7009 to schedule your free estimate. We’ll review your existing layout, confirm your series and finish, and deliver a flat written price with line-item scope before anyone picks up a tool.
Written by Grant Rowan, Owner, Rowan Construction Group Long Beach at Rowan Construction Group Long Beach, serving Long Beach and nearby areas.







Before
After
Before
After
Before
After