ActiveYards Driveway & Pavers Nationwide

ActiveYards Driveway & Pavers: The Long Beach Owner’s Guide

ActiveYards driveway and paver systems installed in Long Beach typically run $7,000-$18,000 for paver driveway installation and $3,500-$11,000 for paver patio work, with most replacement or repair quotes delivered same-day. We stock ActiveYards-compatible edge restraints, bedding sand, geotextile fabric, and polymeric sand in Long Beach, and we carry the paver-specific compaction and cutting tools on our trucks. Most Long Beach homeowners discover their ActiveYards surface is failing when they notice shifting after winter rains, pooling near the street apron, or weed growth between joints that keeps returning no matter how often they pull it.

Call (424) 567-7009

Which ActiveYards Models This Applies To

ActiveYards produces several paver and hardscape lines, and the parts you need depend on which system was originally installed. The most common in Long Beach are the Belgard Catalina and Techo-Bloc Blu series pavers that ActiveYards distributes, along with their proprietary EdgePro aluminum edging and SureBond polymeric sand lines. To identify your part, check the edge of any lifted paver for a stamped series name, or measure the joint width: ActiveYards standard joints run 1/16 inch to 1/8 inch for their tight-lay patterns, and 3/16 inch to 1/4 inch for their permeable installations.

The OEM-versus-aftermarket question matters here. ActiveYards-branded edge restraint is 1/8-inch 6061 aluminum with a specific spike pattern at 12-inch centers. We stock the OEM profile, but we also carry a heavier-gauge equivalent from Permaloc that performs better in Long Beach’s expansive clay soils, which shift more than the sandy loam ActiveYards specs assume. If your original install used ActiveYards’ standard geotextile, it was likely a 4.5-ounce woven; we upgrade that to 6-ounce non-woven on repairs because the port-adjacent soils in parts of Long Beach carry more moisture than inland specs allow for.

Signs Your ActiveYards Driveway & Pavers Is Failing

• Pavers shifting or rocking underfoot. This usually means the bedding sand layer has washed out or the edge restraint has pulled away from the perimeter. In Long Beach, the combination of winter rain and summer dry-out cycles causes the aluminum edging to work loose faster than in more stable climates.
• Pooling water that did not used to collect. The original pitch, typically 1/8 inch per foot, has been lost to settling or subgrade erosion underneath. This is common near downspout outlets where concentrated flow undermines the base.
• Weeds growing through joints despite maintenance. The polymeric sand has degraded or was never fully activated during install. Long Beach’s UV exposure breaks down standard sand binders in three to five years, faster than the seven-year rating assumes.
• Sunken areas near the garage or street apron. The aggregate base was insufficient for the load, or the transition to concrete was not properly pinned. We see this most on installs done between 2015 and 2019, when base depth specs were thinner than current standards.
• Efflorescence, that white chalky film on paver faces. This is mineral migration from the bedding sand or base material, not structural failure, but it signals moisture is moving through the system in ways the original design did not account for. It often precedes freeze-thaw damage in colder microclimates, though in Long Beach it more commonly indicates poor drainage below.

Before

After

Replacement Cost & What’s Included

The range depends on three factors: how much of the base needs rebuilding versus relaying, whether we can match the original paver color (discontinued series require full-section replacement), and access for our compaction equipment. Under Clause 1 of the Haven Standard, you get a written price before any work starts, and no change proceeds without a signed change order. Our 365-Day Done Right Promise covers the workmanship, and the documented photo record shows you the base condition before we cover it back up.

DIY or Call Us?

There is no high-tension danger in paver work, but there is a fast way to waste money. A homeowner can safely check whether edge spikes are loose, measure joint width, or photograph the paver stamp for identification. Where DIY goes wrong is in the base: lifting pavers, adding a bag of sand from the hardware store, and relaying them without plate compaction and proper gradation guarantees the same failure in one rainy season.

We carry plate compactors, laser levels, and moisture-conditioned bedding sand on every driveway and pavers truck in Long Beach. The crew that arrives has already passed background checks and wears Rowan uniforms. If you want to know whether your repair is a $900 relay or a $6,000 base rebuild, call (424) 567-7009 and we will schedule a free estimate with a written price.

FAQs