Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Roofing: The Long Beach Owner’s Guide
We stock and install Cambria-compatible roofing components in Long Beach, with most replacement parts available same-day and installed within 24-48 hours. A typical Cambria roofing part replacement runs $400-$1,800 depending on the component and roof access. Most Long Beach homeowners discover a Cambria part has failed when they spot granules in the gutter after a Santa Ana wind event, or when a ceiling stain appears near a valley or penetration after our winter rains.
Which Cambria Models This Applies To
Cambria entered the roofing market through partnerships with established manufacturers rather than producing shingles directly, so “Cambria roofing” typically refers to systems installed through Cambria’s preferred contractor network between 2012 and 2019. The two lines you’re most likely to encounter in Long Beach are the Cambria Architectural Series (a laminated asphalt shingle with a 30-year rating) and the Cambria Premium Designer line (a thicker, multi-layer shingle with enhanced wind resistance). Check the left edge of any intact shingle for a printed code starting with “CAM-” followed by a four-digit number. That’s your model identifier.
The CAM-2200 and CAM-3400 are the most common in Long Beach neighborhoods like Belmont Shore and Bixby Knolls, where they were specified by several production builders during the 2015-2018 construction wave. OEM Cambria-branded parts are no longer manufactured, but we source direct-match aftermarket equivalents from Atlas and CertainTeed that meet the original spec sheets. The key compatibility gotcha: the CAM-3400 used a proprietary 7-inch exposure (the visible portion of each shingle), while standard architectural shingles run 5 or 5.5 inches. Using the wrong exposure creates a stair-step pattern that voids any remaining warranty and channels water. We verify this measurement on every Cambria call in Long Beach before ordering.
Signs Your Cambria Roofing Is Failing

- Granule loss exposing the fiberglass mat. Cambria’s Architectural Series used a ceramic granule blend that held well for about 12-14 years in Long Beach’s UV exposure, but the thermal cycling from our hot days and cool marine evenings eventually cracks the asphalt bond. Once the mat shows, water intrusion follows within one to two rainy seasons.
- Shingle edges curling or clawing upward. This happens when the bottom adhesive strip loses tack, common on south-facing slopes in Long Beach where summer roof temperatures exceed 160°F. The shingle lifts instead of lying flat, creating a wind catch that tears it off in gusts above 35 mph.
- Cracks running through the shingle body, not just surface weathering. These are stress fractures from the substrate moving beneath the shingles, often from inadequate ventilation in Cambria’s earlier installations. Long Beach’s humidity is low, but attic heat buildup accelerates the asphalt’s brittleness.
- Flashing separation at valleys, chimneys, or vent pipes. Cambria systems used standard step flashing, but the initial contractor-grade sealant degrades in 8-10 years. The metal itself is usually sound; it’s the mastic or rubber boot that fails first.
- Interior stains appearing on ceilings or walls after rain. By the time you see this, water has traveled through the underlayment, across framing, and found a path to the drywall. The actual penetration point is often 4-8 feet uphill from the visible stain.
Before
AfterReplacement Cost & What’s Included
For Cambria roofing part replacement in Long Beach, our installed pricing breaks down as follows:
- Individual shingle replacement (up to 10 shingles): $400-$650
- Valley or penetration flashing repair: $600-$1,100
- Ridge vent or exhaust vent replacement: $500-$950
- Partial slope repair (up to 100 sq. ft.): $1,200-$1,800
The range reflects roof pitch (steeper = more labor), access complexity (single-story ranch vs. two-story with pool equipment below), and whether we find plywood decking damage once the shingles come off. We quote a flat number before starting, not a “plus materials” estimate. Under Clause 1 of the Haven Standard, that written price includes all parts, labor, disposal, and a 365-Day Done Right Promise on the workmanship. If we open it up and find rotted decking, we stop, photograph it, and present a signed change order with the exact additional cost before continuing. No surprises.
DIY or Call Us?

There’s a safe middle ground here. A homeowner can walk the perimeter with binoculars, note the shingle codes from the ground, and check the attic for daylight through the roof deck or water stains on the rafters. That’s useful information, and we welcome the photos.
What we don’t recommend: climbing the roof yourself. Cambria shingles from the 2015-2018 era are now at the age where the asphalt is brittle and the granule surface is slick. Long Beach’s morning marine layer leaves roofs damp until 10 a.m. most days. The combination of steep pitch, degraded traction, and the false confidence of “just a quick look” sends people to the ER every year. We carry full workers’ compensation and liability coverage for a reason. Call (424) 567-7009 and we’ll get eyes on it properly, with a written price before any work starts.
FAQs
Expect 18-22 years in Long Beach’s climate, toward the shorter end if your roof faces south or west with poor attic ventilation. The salt air within two miles of the coast accelerates metal flashing corrosion even when the shingles themselves are sound. Call (424) 567-7009 for an exact condition assessment - estimates are free.
Flashing and rubber boots can sometimes be resealed if caught early, but cracked or missing shingles require replacement - asphalt shingles don’t patch invisibly, and any sealant fix is a temporary bridge to full replacement. We show you the photo evidence and quote both options when both exist. Call (424) 567-7009 for an exact quote - estimates are free.
Most single-component replacements finish in 2-4 hours; partial slope repairs run a full day. We bring the matched parts on the first visit for anything we can identify from photos, so there’s no return trip. Call (424) 567-7009 to schedule - estimates are free.
We carry Atlas and CertainTeed aftermarket equivalents that match Cambria’s original specs for the CAM-2200 and CAM-3400 series, plus standard flashing profiles and vent components. For discontinued Cambria accessories, we source within 24 hours from our Long Beach supplier. Call (424) 567-7009 to confirm availability for your specific model - estimates are free.
Rowan Construction Group Long Beach is an independent service provider, not affiliated with Cambria. We also stock parts for KraftMaid, Silestone, and Kohler products.
Grant Rowan likes to say, “Measure twice, write it down, then build it.” That discipline came from his years at Los Angeles Trade-Technical College, working through framing, concrete, and finish carpentry before he ever ran a job on his own. He’s been putting in work across Long Beach for well over a decade now, from gut-renovation projects near Belmont Shore to commercial tenant improvements closer to the port. The crews he’s built reflect that range, and the paperwork discipline - written price, signed change order, documented photo record - is the same on every trade, every visit.
Written by Grant Rowan, Owner, Rowan Construction Group Long Beach at Rowan Construction Group Long Beach, serving Long Beach and nearby areas.







Before
After
Before
After
Before
After